Raypak Temp-Tracker Especificações descarregar pdf (Página 10)

10 Raypak, Inc.

HTC# 059105-00D



Each of the TempTracker mod+ Hybrid or Extension consists of three primary enclosure components.

• TheEnclosureDisplayModule: contains the control electronic board, display, buttons, LEDs and electric wiring terminals. It has

two screws to hold it to the base. A program conguration switch, used to adjust the control settings, is placed above the terminals.

This switch is enclosed with the enclosure wiring cover for security. Wiring terminals are of the plug-in type to ease installation and

removal.

• TheEnclosureBase: contains the holes to mount and hold the control against the wall or any at surface. All other enclosure

components mount on the base. The bottom section of the Enclosure Base contains the wiring chamber with knockouts on the

bottom to ease installation.

• TheEnclosureWiringCover: seals the wires from the external environment. It has two screws to hold it the base and a hole to

secure a lock on the wiring enclosure. A plastic web that separates the wiring chamber into high and low volt sections has been

provided.



• Select a location near the equipment to be controlled.

• The surface should be at and sufciently wide and strong to hold the TempTracker mod+ Hybrid or the Extension.

• Keep the control away from extreme heat, cold, or humidity. Ambient operating temperature is from 20 to 120°F.

• Remove the Enclosure Wiring Cover from the control enclosure by removing the two bottom screws.

• Remove the Enclosure Display Module by removing the enclosure middle screws.

• Screw the Enclosure Base to the surface through the upper and lower mounting holes on the back of the enclosure.

• Replace the Enclosure Display Module and replace the enclosure middle screws.

• Do not replace the enclosure wiring cover until all wiring is done.

• When purchasing a padlock for the enclosure, the maximum shank diameter should not exceed ¼"

Enclosure Display Module

Enclosure Wiring Cover Enclosure Base

Hole for optional lock

(not supplied)

Mounting Holes

Display Mounting Screws

Wiring Cover

Mounting Screws

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

Sem comentários

Raypak Temp-Tracker Especificações Página 10